How to weld the hinges on the gate?

If you are not a professional welder, but with all my heart want to do welding work on their own, we can please you - welding hinges on the gate or welding hinges on the gate, it is not as difficult as it seems, and you may well be able to carry out its own hands.

Hinges - is the main functional element of future construction. The main function of the loop - opening and closing of the gate or gates.

Methods of welding hinges on the gates vary mainly depending on the material you have chosen as the basis for your gate, as well as - the material supporting pillars (pillar of brick, concrete or round metal pole).

When choosing the loop for future gate, better to give preference to low-maintenance and more reliable loops. For example, loops with balls.
The process hinges on the correct welding garage doors

In welding, it is important to observe safety precautions. Therefore, you should prepare in advance for a protective mask and gloves.

Root welding process is better when the gate is still lying on a flat surface. Hinges should be lubricated with grease in advance.

Stages welding garage loops:
For starters, you need lining thickness of 2 to 5 millimeters. The gasket is necessary to slip under the lower part of the loop;
The upper part of the loop, you can grab an end;
Followed differences, as discussed earlier, depending on the shape of the post.
How to weld hinges to a round pillar?

Loops are issued by 5 millimeters out.
How to weld the hinges to the square pillars?

Cook should be flush technology is the same for both loops. Hinges need to grab and use the rectangular bar - to expose them.

Set the shutter curtain vertically;
Check plumb;
Attach the hinges to the gate and check if they are on the same line, parallel to the edge of the gate;
Welding hinges. First of all, the door leaf, and the second to the stakes. Make sure that the welding seam vertical and quality;
After welding, clean the welds grinder.
Why mounting plate?

In some cases, in order to simplify the welding work, and at the same time evenly distribute the load, pre-welded to the hinge plates of a special metal.

The shape and size of the plate depends on the weight and thickness of the metal gate leaf. In addition, the plate may well perform a decorative function.
Hidden internal hinges are welded on the gate

If you have a need for welding to the gate of the inner loop (hidden), it is best to consult a professional, it's quite time-consuming technique that requires the hands of an experienced welder and his hands you can not cope with it.
As welded loop at the gate of corrugated board?

The pattern that is going to frame out of the leaf shaped tube.

The process is as follows:
Make two jumpers, parallel top and bottom long side flaps and secure gons;
The distance between the beams must be such that the sash was divided into three equal portions;
These jumpers welded hinges gate;
Decking is screwed on top of already welded loops. Best fit garage loop length not less than one meter, the thicker the material, the better. We do not recommend the use of material thinner than 3 millimeters.